manualshive.com logo in svg

Magnum Country Flame MF3626, Quick Start Manual, Page: 2 / 4

Share
Download
Magnum Country Flame MF3626 Quick Start Manual Download Page 2

F:\AESBusinessSystems\AES Technical\Piece part instructions\MF3626 Door handle Assembly.doc 

Door Handle Assemble Kit 

Part #MF3626 

For Models Baby Countryside & Winchester units 

 

 

 
 
 
 
   
 
 
 
 
 

 
 
 
 

•

 

Verify the collar is adjusted to 2 ¼” from the 
end as shown.   

 
 
 
 
 
 

 

•

 

Slide the handle through the door and into the 
spring and cam as shown.  Line the set screw on 
the cam up to the dimple in the door handle. 

•

 

Tighten the set screw. 

•

 

If adjustment necessary. 

•

 

To adjust the door latch press the cam against 
the door, slide the collar toward the cam until 
the allen wrench hits the door and can go no 
further. 

•

 

Tighten the set screw 

 
 
 
 

 
 
 
 

Dimple on door handle 

Summary of Contents for Country Flame MF3626

Page 1: ... place with two 2 clips on the top and two 2 clips on the bottom Open the door and lift door off of hinges If the door is tight tap gently on the bottom of the door with your hand or a rubber hammer Lay the door down on newspaper with the glass clips facing you Using a number two 2 Phillips screwdriver loosen the screws and take the glass clips off Remove the broken or damaged glass carefully If g...

Page 2: ...d to 2 from the end as shown Slide the handle through the door and into the spring and cam as shown Line the set screw on the cam up to the dimple in the door handle Tighten the set screw If adjustment necessary To adjust the door latch press the cam against the door slide the collar toward the cam until the allen wrench hits the door and can go no further Tighten the set screw Dimple on door hand...

Page 3: ...ed in the photo below gives a visual indication that the pressure will be fairly even across the door This is a approximate measurement but will give you a quick idea if the hinge pins need to be adjusted 5 The 2nd test confirms that the pressure is strong enough to provide a tight seal As you close the door the gasket on the hinge side should start to compress against the left frame when the cam ...

Page 4: ... the distance between the top of the doorframe and the edge of the main body Then measure between the bottom of the doorframe to the edge of the main body The difference between the 2 measurements must be 2 mm 06 or less Chalk the doorframe as shown and then latch the door tight to transfer the chalk from the doorframe to the rope gasket Open the door and see that the chalk lines are approximately...

Reviews:

No comments