Magnum Industrial MI-91340, Operating Manual, Page: 12 / 20

RECOMMENDED ADJUSTMENTS
ADJUSTING THE 90º TABLE STOP AND RE-ALIGNING THE ANGLE POINTER
To ensure that your 90º cuts are square and that angled cuts are accurate with the angle indicator scale, the table
default position must be set to 90º to the blade and the angle indicator pointer must be set to read 0 when the table
is in the default (90º) position. To set the table-stop bolt:
1. Loosen the two lock knobs A. 2. Place a combination square B flat on the table
with the heel of the square flat against the saw
blade C.
3. Level the table until it is exactly 90° to the blade,
then tighten the lock knobs A.
4. Adjust the height of the table-stop bolt until it
touches the underside of the table D.
5. Turn the jam-nut E clockwise until it meets the
table tilt-bracket F and tighten it.
6. Loosen the lock knobs G and make sure the table
is resting on the table-stop bolt D.
7. Check the square and make sure the table is still
at 90° to the blade. If not, re-adjust the table-stop
bolt.
Never adjust the table angle while the bandsaw
is running. Turn off power first.
1. Loosen the two lock knobs A.
2. Tilt the table until it is at the desired angle. (Refer
to the angle indicator under the bandsaw table.)
3. Tighten the lock knobs to lock the table in
position.
You will now be able to accurately return the table to the 90º position automatically without further
adjustments and scale reading for any angle other than 0 will also be accurate.
TILTING THE TABLE
The table can be tilted to any angle from 0° to 45° to the right, to allow for any type of bevel (or angle)
cutting. Refer to the table tilt angle indicator to set the angle of the table to the desired position.
8. With the table set to 90º and the stop bolt at the
correct height, make sure the table tilt angle
indicator pointer H is set to read 0º.
9. If the pointer needs to be adjusted, loosen the
screw I on the pointer of the front trunnion and
adjust the pointer H to the 0 point on the scale.
Then re-tighten the screw to secure the pointer in
place.