Magnum Industrial MI-31662, Operating Manual

Page: 6 / 34

CHANGING VOLTAGE
If you must reconnect for 220 or 440-volt operation, please contact or have a certified electrician connect the
machine to the power source.
GROUNDING
Machine must be properly grounded in order to avoid electric shock to
the work operator. The use of an extension cord is not recommended. If
necessary use a three-prong extension cord and outlet (immediately
replace the extension cord if worn out, cut or damage). If in doubt,
contact a qualified electrician.
OPERATING CONTROLS & ADJUSTMENTS
START / STOP SWITCH (Fig.13)
The power switch is located on the left side of the machine. Press the
green button to start the machine (A)
Press the red button “Emergency” to stop the machine (B)
RAISING & LOWERING THE TABLE (Fig.14)
Adjustment to the table height can be made by loosening lock knob (A)
and rotating the raising lowering of table with handwheel (B).
To raise table: turn the handwheel (B) clockwise.
To lower table: turn the handwheel (B) counter-clockwise.
Tighten lock knob (A), after table height adjustment is made in order to
lock in position.
The metric table height scale (C) will indicate the table height setting.
Note: For best result, setting of the table should always be made from
the bottom to upward position.
ADJUSTING FEED SPEED (Fig.15)
1. The feed speed for the planer is variable from 20 to 38.7 FPM.
2. Use the speed selector knob (A); in order to change the feed speed
3. Turn he speed selector knob clockwise to decrease the feed speed.
Turn counter-clockwise to increase feed speed.
Important: Never change the feed speed when machine is stopped;
change the feed speed only while the machine is running.
FIG.13
FIG.14
FIG.15