Magnum Industrial MI-15300, Operating Manual

Page: 4 / 11

A 3/8-16 x 3/4" Hex bolt, 2 each
B 3/8" Flat washer, 4 each
C Tool rest bracket (left & right), 2 each
D Tool rest (left & right), 2 each
E
5/16" Flat washer, 2 each
F 5/16-18 x 1" Knob, 2 each
G #10-24 x 1/2" Pan head screw, 4 each
H Upper eyeshield bracket, 2 each (left and right)
I Eyeshield, 2 each
J
Lower eyeshield bracket, 2 each
K 3/8" Lock washer, 2 each
L 1/4-20 x 3/8" Knob, 2 each
M Spark guard (left and right), 2 each
N 3/8-16 x 1/2" Knob, 2 each
Dust collector hose not shown.
TOOL REST ASSEMBLY
1. Place tool rest (D) over tool rest bracket and secure
in position with 5/16" flat washer (E) and 5/16-18 x 1"
knob (F).
2. Attach tool rest bracket to the bot- tom of the left
wheel guard using one 3/8-16 x 3/4" hex head bolt (A)
and one 3/8" flat washer (B). Make sure that the slot
of the bracket is located over the raised boss on the
guard. Tighten bolts finger tight.
3. Position tool rest so that distance between tool
rest and grinding wheel is less than 1/16".
Reposition angle of tool rest if necessary. Secure all
knobs and bolts.
4. Mount right tool rest in a similar manner.
EYESHIELD ASSEMBLY
1. Attach spark guard (M) to left wheel guard using 3/8-16 x 1/2" knob (N). 3/8" flat washer (B) and
3/8" lock washer (K).
2. Mount left upper eyeshield bracket (H) to eyeshield (I) using two #10-24 x 1/2" pan head screws (G)
and lower eyeshield bracket (J).
NOTE: Left upper eyeshield bracket is stamped "L" for identification.
3. Slide 1/4-20 x 3/8" knob (L) through hole at top of left spark guard (M) Into upper eyeshield bracket
(H) and secure in position.
Assembly (Continued)
4. Locate eyeshield In desired position for protecting operator and secure all knobs and bolts.
5. Mount right eyeshleld assembly in a similar manner.
DUST COLLECTOR HOSE
A dust collector hose has been provided with grinder. Slide hoses onto sides of T-connector and
flanges. Mount the hose by sliding the flanges at each end over the exhaust ports on the left and right
wheel guards. Attach 2-1/2" shop vacuum hose to collector hose. Be sure hose is mounted securely.
DANGER
Be sure to empty shop vacuum of all flammable material (flammable liquids
and vapors, paper, wood, plastic, etc.) before connecting vacuum to grinder. Hot sparks
from grinder may ignite flammable materials in shop vacuum.
OPTIONAL LIGHTED
EYESHIELD
Position eyeshield bracket assembly over bosses provided on wheel guard. Bosses are tapped to
Figure 1- Left Tool Rest and Eyeshield
Assembly