©
2010 Magnum Energy, Inc
.
Surface Mounting
The remote control can be mounted on the surface of a wall by
using the mounting ring.
Info:
The mounting ring has tabs at the top and bottom
that are made with a thinner material. This enables the
tabs to be cut or broken out to allow the communication
cable to be routed up or down the wall.
1.
Using the mounting ring as a template, mark on the wall the
location of the four mounting screws.
2. Drill appropriately sized holes (depending on screws used
– these are not supplied) in the four screw locations that were
marked.
3. Determine if the communication cable will be running up or
down or through the wall, and then cut/break the appropriate tab
on the mounting ring.
4.
Pull the cable through the mounting ring and place the ring side
with the removed tab over the communication cable against the
wall.
5. Position the mounting ring over the drilled holes and screw the
mounting ring to the wall.
6. Connect the communications cable — routed through the
mounting ring opening — to the RJ11 connector on the rear of the
remote display.
7. Secure the remote display to the mounting ring with the 2
Phillips screws provided.
8. After ensuring the inverter is OFF, route the communications
cable exiting from the mounting ring into the REMOTE port on the
front of the inverter.
Figure 4, Surface Mounting
4
2.0 Installation
BULK
ABS ORB
FAULT
FLOAT
AC IN
INVE RT
ON /OFF
breakable tab
(allows cable to
be inserted)
Communication cable
(routed on or through the wall)
screws x4
(not included )
Mounting Ring
