EN
EN
EN
1. After cleansing, generously apply your favourite
nourishing or hydrating skin serum or moisturiser
(*not included) (F).
DO NOT
use exfoliating serums,
acids or activated products as this may cause
irritation.
2. Switch the device on by holding the power button
for 3 seconds and then press to activate Moisturising
Mode (G).
3. Using the flat side of the metal spatula (H), glide
upwards across your skin using a gentle pressure (I)
and watch your serums sink in!
4. Once you’ve covered your whole face, press and
hold to switch off your device, wipe clean the
spatula using a damp cloth with soap and water (E).
DO NOT
rinse or submerge in water.
1. Before you begin, make sure your skin is fully
cleansed - free of makeup, surface oils and daily
grime. (Men should shave before treatment as facial
hair can interfere with conductivity)
IMPORTANT: Any cream, lotion, self-tan, or other
oil-based products on the skin can block the
microcurrent.
2. Switch the device on by holding the power button
for 3 seconds and then press twice to activate Lifting
Mode (J).
3. Apply a generous layer of LiftOff Superconductive
Gel (*not included) (K). It is best to do this section by
section. You can reapply during treatment if your skin
becomes dry.
*To buy LiftOff Superconductive Gel, please visit
www.magnitone.co.uk
4. Starting at the chin, place the flat side of the spatula
flush to your skin (H) and gently glide along the
jawline, up to the ear, on one side of your face.
Repeat 2 more times. 3 x 'reps' in total.
5. Using this same motion, move on to the next section
of your face and continue to work clockwise/
anti-clockwise around your face (L).
DO NOT
use
MOISTURISING MODE
The ultrasonic waves + negative ion technology help the
skin to absorb and infuse the product. Can be used daily.
LIFTING MODE
Small pulses of microcurrent stimulate the muscles,
encouraging blood flow + collagen production.
Recommended use - 3-4 times per week for 4 weeks
(to see results), then 1-2 times per week ongoing (to
maintain).
M
L
J
K
F
G
H
I