8) Continued
10) Fit stiff 1.6mm square strip angled stringers between F2 and F3
on the top and both sides as indicated.
8) Fit all other formers and cross pieces top and bottom working
from F7 backward, ensuring that the fuselage remains square and
true in all directions.
9) Fit and glue the remaining rear stringers, making them from light
1.6mm square strip, ensuring that the ends are bevelled to fit each
other and the fuselage sides as instructed on the plan.
7)…Hold the ends together with a clothes peg or similar until the
glue is set, then round off the end as shown on the plan.
9) Using stiff 1.6mm square strip, fit and glue the ‘backbone’
stringer in position. Note that the end sits on top of the fuselage
sides at the rear.