Magnetic MHTM FlowMotion, Manual, Page: 12 / 80

12
Control unit MGC
Digital inputs, digital outputs and relay outputs
2.2 Digital outputs and relay outputs
Definition of "Left" and "Right":
ä
Page 58, chapter 7.1.
By parameterising the outputs, you assign certain functions to the outputs. For
example, if you parameterise the "Buzzer/Siren (alarm)" function for output
NO2, you must connect an acoustic signal transmitter to this output.
If the function is marked with "|", the output is inverted (Fail Safe).
The following functions are assigned to the outputs as default settings:
Clamp Description Function
DO1 Digital output 1 Floor illumination
DO2 Digital output 2 Buzzer/Siren (alarm)
DO3 Digital output 3 Locking
DO4 Digital output 4 –
NO1 Relay output 1 LED strip red
NO2 Relay output 2 LED strip green
NO3 Relay output 3 –
NO4/NC4 Relay output 4 Passage clear Left
NO5/NC5 Relay output 5 Passage clear Right
NO6/NC6 Relay output 6 Closed
Table 5: Factory setting digital outputs and relay outputs
NOTICE
Changing the assignment of the terminals DO1, DO2, DO3, NO1,
NO2 and NO3 and the factory default functions!
By default, the terminals are wired for the listed factory settings.
A change will cause the pedestrian gate to malfunction.
›
Do not change the assignment of the listed terminals.
Function Description
– Outputs that you assign this function "–" to are deactivated.
| Error When the control unit recognises a "Safety-relevant error" or an "Error", the
output with this function is deactivated (fail safe).
ä
Page 63, chapter 8.3.
| Warning When the control unit recognises any "Warning", the output with this
function is deactivated (fail safe).
ä
Page 63, chapter 8.3.
Gate ready Pedestrian gate is ready for operation
This output is activated as soon and as long as the pedestrian gate is ready
for operation.