Magnetic Autocontrol MHTM MicroDrive, Operating Instructions Manual

Page: 91 / 196

Barrier MHTM
TM
MicroDrive
Electrical connection
5815,5001US / Version 02.66 91
9.2 Installing electrical protective devices
The safety installations that are required according to regional and
local regulations must be provided by the customer. Usually these
are:

Ground fault circuit interrupter (GFCI)

Circuit-breaker

Appropriate listed 2-pole main switch.
9.3 Connecting the mains supply
Electrical voltage
DANGER!
DANGER!
Danger to life from electric shock!
If the mains supply is not connected to the terminal
clamps correctly, loosens from the terminal clamps
and touches the housing or door, there is a direct
danger to life from electric shock.
Therefore:
– Have work at the electrical system only
performed by electricians.
– Connect mains supply according to the
following description.
– Install electrical protective devices according to
chapter 9.2, national and local codes.
– Perform proper grounding.
NOTE!
The wire cross-section of the mains line must be
between 16 and 12 AWG (1.5 and 4 mm
2
).
Observe national provisions on line length and
associated cable cross-section.