Magnetic Autocontrol MHTM MicroDrive, Operating Instructions Manual

Page: 154 / 196

Barrier MHTM
TM
MicroDrive
Start-up and operation
154 5815,5001US / Version 02.66
11.4 Putting the barrier temporarily out of operation
High wind speeds
WARNING!
WARNING!
Risk of injury from barrier arm in case of high
wind speeds!
The barrier arm is no longer securely locked with
the mains voltage off. At high wind speeds, the
barrier arm can be pressed from its end position.
The moving barrier arm can severely injure a
person.
Therefore:
– Keep supplying the barrier with mains voltage.
– Remove the barrier arm if necessary.
NOTICE!
NOTICE!
Possible damage to the equipment by
condensed water when mains voltage is
switched off!
Therefore:
– Keep supplying the barrier with mains voltage.
If the barrier is put out of operation for a longer period, proceed as
follows:
1. Switch off barrier.

See page 152, chapter 11.3.
2. Remove the barrier arm if necessary.

See page 170,
chapter 14.2.
3. Protect the barrier from corrosion and contamination.
4. Switch on barrier.

See page 152, chapter 11.3.