Telemotive MLTX , SLTX and Pendant BatteryCharger Instruction Manual—04/27/2007
6
MULTIPLE CHARGER INSTRUCTIONS (Max. 3)
1.
Plug charger power supply adapter into 120 VAC 60 Hz power source. Plug the adapter jack in the charger base
connection labeled “IN”. The Green “POWER” light will come on indicating the unit is receiving power.
2.
You can only use up to three chargers with one power supply.
Using more will damage the charger and power
supply. This will also void the warranty.
3.
In the charger that has the power supply adapter, plug the parallel cable (WA1066-0) in that charger base
connection labeled “OUT”.
4.
In the next charger, plug the other end of the parallel cable (WA1066-0) into the charge base connection labeled
“IN”. The Green “POWER” light will come on indicating the unit is receiving power.
5.
If necessary, repeat steps 3 and 4 for last charger.
6.
Insert the batteries into the slot until the battery settles on the bottom. The Red “Fast Charge” LED will light
indicating fast charging has begun.
7.
When the battery is charged, the Red “Fast Charge” LED will turn off and the charger will automatically switch to
trickle charge.
8.
For best battery performance, avoid charging the battery pack for more than 24 hours at a time.
Conditioning:
A new rechargeable battery pack may experience a low usable capacity during the first few charge cycles
due to long storage. Do not be concerned.
If there are any problems or questions in the operation of this unit please call our technical support at 1-866-MAG-
SERV (1-866-624-7378).
Green
“It’s Powered”
Red
“Fast Charge”
