(E)
7
SR84 / SR85, CH33
Fig. 11
Fig. 10
2.
Adjust the parallelism with respect to the machine guide of the scale rear while measuring the scale rear
with a dial gauge. Tighten the set screws.
<Measurement method>
Measure near the installation hole positions at the scale unit rear.
3.
Insert the supplied spacer (t = 1.0 mm) in the space between the scale and slider, and then adjust the
slider position while bringing the slider into contact with the scale.
■
■
■
■
■
Air injection and oil lubrication
In the standard configuration, the end cap section is provided with an M5 tap hole for air injection and oil
lubrication. For more detailed information, please refer to the Instruction Manual (sold separately).
Unit: mm
0.1
MG
spacer (t = 1.0 mm)
Summary of Contents for SR84
