MagneMotion MagneMover LITE, User Manual, Page: 231 / 382

Installation
Option Installation
MagneMover LITE User Manual 45
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
Assemble Precision Rail Support Posts
The precision rail support posts should be loosely assembled as shown Figure 5-27 .
NOTE: This step may be skipped if the support posts are supplied pre-assembled.
Figure 5-27: Precision Rail Support Post Assembly
1. Insert two M8 T-nuts into the channel on the top of the post mount and rotate into posi-
tion.
2. Loosely attach the support post to the post mount using two M8 x 16 mm SHC screws
and M8 washers (finger-tighten then back off one half turn) to provide the parts a
small amount of movement relative to each other to allow adjustment.
3. Loosely attach the appropriate spine plate to the post mount using two M6 x 16 mm
Low Head SHC screws (finger-tighten then back off one half turn) to provide the parts
a small amount of movement relative to each other to allow adjustment.
NOTE: Ensure the rail mounting edge of the spine plate is oriented towards the con-
nector plate on the post mount.
4. Position the support post base 38 mm [1.50 in] from the end of the connector plate on
the post mount as shown in
Figure 5-28 and tighten the M8 screws to 26 N-m
[230 in-lb] using 6 mm Hex wrench.
Spine Plate
Support Post
Connector Plate
M6 x 10 mm
Low Head Socket
Cap Screw (2X)
M8 x 16 mm SHC Screw
(2X)
M8 T-Nut
(2X)
M8 Flat Washer
(2X)
Post Mount Cap
Post Mount
M8 T-Nut
M8 x 20 SHC Screw
(2X)