MagneMotion MagneMover LITE, User Manual, Page: 207 / 382

Installation
Transport System Installation
MagneMover LITE User Manual 21
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
2. Locate the motor or switch so that the protruding boss on the standard motor mount is
keyed into the beam and aligned to the T-nut, install an M8 x 20 mm bolt and M8 split
lock washer as shown in
Figure 5-10 and finger tighten.
3. Using the Motor Alignment Fixture adjust the position of the motor or switch along
the beam so it is properly centered on the beam as shown in
Figure 5-11 (ensure the
fixture is fully seated in the slot in the beam). For switches, also adjust the position of
the switch on the motor mount to ensure the third face is properly positioned. Tighten
the M8 bolt securing the motor mount to the beam to 26 N-m [230 in-lb] using a
13 mm Hex socket.
Figure 5-11: Positioning Motors and Switches
Table 5-2: Motor Mount Reference
Motor Type
Motor Mount
Qty Location
250 mm Motor 1 Center of beam
1000 mm Motor 2 25 cm from each end of beam
125 mm R 90° Curve Motor 1 Center of beam
*
* Ensure the beam is oriented so that all internal fastening hardware in located on the
bottom of the beam.
Left or Right Switch 1 Center of beam
Motor Alignment Fixture