MagneMotion MagneMover LITE, User Manual, Page: 205 / 382

Installation
Transport System Installation
MagneMover LITE User Manual 19
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
Installing Motor Mounts on Motors and Switches
The motor mounts should be installed on the motors before installing the motors in the trans-
port system to provide ease of installation. This procedure applies to both the standard motor
mount bracket, shown in
Figure 5-9 , and the adjustable motor mount bracket.
NOTE: Installing the motor mounts is the same for motors with rails and for railless motors.
Figure 5-9: Installing Motor Mounts on Motors and Switches
1. Place a motor or switch upside down on a clean work surface.
2. Locate the flat end of the motor mount against the motor at the mounting hole (for
adjustable motor mounts this is the end with the two nylon tipped set screws). Ensure
the orientation of the cable chase mounting brackets for curve motors and switches is
correct (refer to
Figure 5-9 ).
NOTE: The 1 m motor requires two motor mounts.
When using adjustable motor mounts, ensure the lock nut on the set screws is
loose.
3. Secure the motor mount to the motor using an M6 x 20 mm bolt and M6 split lock
washer as shown in
Figure 5-9 and finger tighten.
AT
E
IN TEG
BU
RN
TES
TED
????
????
?
Made
in U
SA
www
.mag
nem
otion
.com
XX V
DC, X
.X A T
yp, X
.X A M
ax
S/N:
P/N:
700-1
308-X
X
ATE
PU
CK
B-IN
TES
TED
???
???
???
ww
w.m
agn
em
otio
n.c
om
XX
VD
C, X
.X
A T
yp,
X.
X A
M
ax
Pow
er:
S/N
:
P/N
:
700
-13
08-
XX
Ma
de
in
US
A
????
????
?
www
.mag
nem
otion
.com
XX V
DC, X
.X A T
yp, X
.X A
Max
Pow
er:
S/N:
P/N:
700-1
308-X
X
Made
in U
SA
AT
E
PU
CK
B-IN
TES
TED
M6 x 20 mm Bolt
M6 Lock Washer
Straight Motors (typ)
Curve Motors (typ)
Switches (typ)