Installation
Transport System Installation
MagneMover LITE User Manual
5
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
Transport System Installation
The MagneMover LITE transport system must be properly located in the facility so that other
equipment can interface to it as required. The location must also ensure that there is adequate
space for service access and for proper operation. Ensure that installation of the MagneMover
LITE components provides access to items required for service after installation, such as con-
nection panels. Once properly located, the MagneMover LITE transport system should be lev-
eled and secured to the floor or other rigid mounting points designed as part of the system to
prevent any movement.
Installing Hardware
These hardware installation procedures assume use of the MagneMover LITE stand system to
support the motors and switches.
To install the motors and switches on user-supplied supports ensure the supports are properly
prepared to receive the motors and switches (refer to
Install the motors and switches (refer to
any adjustment necessary to account for the custom supports.
NOTE:
Any bolts with plastic caps have been pre-tightened at the factory to the appropriate
torque specification and do not need to be tightened during installation.
When performing any of the following procedures, adhere to and follow all safety
warnings and instructions.
Required Tools and Materials
•
Metric Hex wrench set.
•
Torque wrench (0.9 - 26 N-m [8 - 230 in-lb] range) with metric and Torx bits.
•
Screwdriver, Small flat blade.
•
Screwdriver, Phillips.
•
12” Machinist Square.
•
Laser level, rotary.
•
Digital Multimeter.
•
Loctite 243, Thread locker, Anaerobic Adhesive, Blue.
•
Loctite 290, Thread locker, Wicking Grade, Green (Precision Rail option only).
•
Open end wrench, 13 mm, thin (Precision Rail option only).
•
Ratcheting Hex wrenches; 10 mm, 13 mm, 14 mm, 17 mm.
•
000-0616-00 – Motor Alignment Fixture, ML.