3
EN
Before Using
conductors, location of antenna-discharge unit,
connection to grounding electrodes, and requirements
for the grounding electrode. (Fig. A)
14. Lightning -
For added protection for this product
receiver during a lightning storm, or when it is left
unattended and unused for long periods of time,
unplug it from the wall outlet and disconnect the
antenna or cable system. This will prevent damage to
this product due to lightning and power-line surges.
15. Power Lines -
An outside antenna system should not
be located in the vicinity of overhead power lines or
other electric light or power circuits, or where it can
fall into such power lines or circuits. When installing an
outside antenna system, extreme care should be taken
to keep from touching such power lines or circuits as
contact with them might be fatal.
16. Overloading -
Do not overload wall outlets and extension
cords as this can result in a risk of fi re or electric shock.
17. Object and Liquid Entry -
Never push objects of any
kind into this product through openings as they may
touch dangerous voltage points or short out parts that
could result in a fi re or electric shock. Never spill liquid
of any kind on this product.
18. Servicing -
Do not attempt to service this product
yourself as opening or removing covers may expose
you to dangerous voltage or other hazards. Refer all
servicing to qualifi ed service personnel.
19. Damage Requiring Service -
Unplug this product from
the wall outlet and refer servicing to qualifi ed service
personnel under the following conditions:
a. When the power-supply cord or plug is damaged
or frayed.
b. If liquid has been spilled, or objects have fallen into
this product.
c. If this product has been exposed to rain or water.
d. If this product does not operate normally by
following the operating instructions. Adjust only
those controls that are covered by the operating
instructions, as improper adjustment of other
controls may result in damage and will often
require extensive work by a qualifi ed technician to
restore this product to its normal operation.
e. If this product has been dropped or damaged in
any way.
f.
When this product exhibits a distinct change in
performance-this indicates a need for service.
20. Replacement Parts -
When replacement parts are
required, be sure the service technician has used
replacement parts specifi ed by the manufacturer that
have the same characteristics as the original part.
Unauthorized substitutions may result in fi re, electric
shock, injury to persons or other hazards.
21. Safety Check -
Upon completion of any service or
repairs to this product, ask the service technician to
perform routine safety checks to determine that this
product is in proper operating condition.
22. Heat -
This product should be situated away from heat
sources such as radiators, heat registers, stoves, or other
products (including amplifi ers) that produce heat.
GROUND CLAMPS
NEC - NATIONAL
ELECTRICAL CODE
FIGURE A
EXAMPLE OF ANTENNA GROUNDING AS PER
NATIONAL ELECTRICAL CODE
GROUNDING
CONDUCTORS
(NEC SECTION 810-21)
ANTENNA LEAD
IN WIRE
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)
POWER SERVICE GROUNDING ELECTRODE
SYSTEM (NEC ART 250, PART H)
GROUND CLAMP
ELECTRIC SERVICE
EQUIPMENT
The serial number of this product may be found on the bottom of the unit. You should record the number and
other vital information here and retain this book as a permanent record. Serial numbers are not kept on fi le.
Date of Purchase
Dealer Phone No.
Dealer Purchase from
Model No.
Dealer Address
Serial No.
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY
INSERT.
ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE
LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU
FOND.
Do not place the unit on the furniture that is capable of being tilted by a child and an adult leaning, pulling,
standing or climbing on it. A falling unit can cause serious injury or even death.
X6043UD_TB110MW.indd 3
X6043UD_TB110MW.indd 3
2008/05/29 14:28:29
2008/05/29 14:28:29
