AMPLIFIER
Output power
PMPO ..................................................................... 60 W
RMS ............ 2 x 1W (1KHz/10% THD/8 ohms)
RADIO
FM wave range .................................. 87,5-108 MHz
MW(AM) wave range ..
526,5-1606,5 KHz
KHz
CD PLAYER
Programmable tracks ............................................... 20
Signal-to-noise ratio ..................................... ≥ 55 dB
Channel separation ............... ≥ 40 DB (1 KHz)
Harmonic distortion..... < 1%(10 KHz,-20 dB)
GENERAL
AC power....................................................... 120/230 V
..................................................................50 / 60 Hz
DC power ...................................................... 6 x 1,5 V
Power consumption
Active ...................................................................... 12 W
Stand-by.......................................................................
1 W
Dimensions (wxhxd) ..........
290x143x240
(mm)
Weight (without package)..........................
1,62
Kg
Specifications are subject to change
Problem
–
Possible cause
• Remedy
No sound /power
–
Volume not adjusted
• Adjust the VOL
–
Power cord not securely connected
• Connect the AC power cord properly
–
Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
–
Headphones connected to the set
• Disconnect headphones.
–
CD contains non-audio files
• Press
∞
,
§
once or more to skip to a CD audio
track, instead of the data file.
Display does not function properly / No
reaction to operation of any of the
controls
–
Electrostatic discharge
• Switch off and unplug the set. Reconnect after a
few seconds
--
,
Er
or
01
indication
–
No CD inserted
• Insert a CD
–
CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
–
Laser lens steamed up
• Wait until lens has cleared
–
CD-R/CD-RW is blank or not finalized
• Use a finalized CD-R/CD-RW or suitable CD
Audio disc only
Note:
Make sure the CD is not encoded with
Copyright protection technologies, as some
do not conform to the Compact Disc stan-
dard.
The CD skips tracks
–
CD damaged or dirty
• Replace or clean CD
–
Program
/Shuffle
is active
• Quit program/
shuffle
mode
Note: A CD badly scratch or dirty may result in
improper operation
.
Poor cassette sound quality
–
Dust and dirt on the heads, etc.
• Clean deck parts, see Maintenance
–
Use of incompatible cassette types (METAL or
CHROME)
• Only use NORMAL (IEC I) for recording
Recording does not work
–
Cassette tab(s) may be broken
• Apply adhesive tape over the missing tab space
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING:
Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
Environmental information
All unnecessary packaging material has been omitted.The packaging can be easily separated
into three materials: cardboard, polystyrene and plastic.
Your set consists of materials which can be recycled if disassembled by a
specialized company. Please observe the local regulations regarding the
disposal of packaging, dead batteries and old equipment.
Specifications
