background image

9

3. Clean the air filter

Remove the filter every two weeks in normal 

operating conditions.

Remove the filter from the top of the unit (See Fig.11a), 

or remove the Bucket then pull 

(See Fig.11b).

filter downwards 

Wash the filter with clean water then dry.

Re-install the filter, replace Bucket.

CAUTION:

DO NOT operate the dehumidifier without a filter

because dirt and lint will clog it and reduce

performance.

Turn off the unit, wait one day before emptying 

the bucket.

Clean the main unit, water bucket and air filter.

Cover the unit with a plastic bag.

Store the unit upright in a dry, well-ventilated place.

 

Wrap the cord and bundle it with the band(Fig.12) .

4. When not using the unit for long time periods

CARE  AND  MAINTENANCE

Care and cleaning of the dehumidifier

Turn the dehumidifier off and remove the plug 
from the wall outlet before cleaning.

1. Clean the Grille and Case

Use water and a mild detergent. Do not use bleach 

or abrasives.

Do not splash water directly onto the main unit. Doing

so may cause an electrical shock, cause the insulation

to deteriorate, or cause the unit to rust.

The air intake and outlet grilles get soiled easily, so use

a vacuum attachment or brush to clean.

2. Clean the bucket

Every few weeks, clean the bucket to prevent growth of mold,

mildew and bacteria. Partially fill the bucket with clean water 

and add a little mild detergent. Swish it around in the bucket,

empty and rinse.

NOTE:

 Do not use a dishwasher to clean the bucket.

After cleaning, the bucket must be in place and securely 

seated for the dehumidifier to operate.

Fig. 12

Fig. 11a

Fig. 11b

or

TROUBLESHOOTING  TIPS

Before calling customer service, review the chart below first yourself.

Problem

What to check

Unit does not start

Make sure the dehumidifier power plug is pushed completely 

into the power outlet.

Check the house fuse/circuit breaker box.

Dehumidifier has reached its preset level or bucket is full.

Water bucket is not in the proper position.

Did not allow enough time to remove the moisture.

Make sure there are no curtains, blinds or furniture blocking 

the front or back of the dehumidifier.

The humidity control may not be set low enough.

Check that all doors, windows and other openings are 

securely closed.

O

O

Room temperature is too low, below 5 C(41 F).

There is a kerosene heater or something giving off water 

vapor in the room.

,

The air filter is clogged.

The unit is tilted instead of upright as it should be.

The floor surface is not level.

This is normal. The dehumidifier has Auto defrost feature.

Hose to connector or hose connection may be loose.

Intend to use the bucket to collect water, but the back 

drain plug is removed.

These are error codes and protection code. See the 

DEHUMIDIFIER CONTROL PANEL

 section.(page 4) 

10

Dehumidifier does 

not dry the air as 

it should

The unit makes a 

loud noise when 

operating

Frost appears 

on the coils

Water on the floor

ES, AS, P2, or EC 

appear in the display

Summary of Contents for D-60ES







Reviews: