English
Française
Español
5
Note:
The first time
(and only the first time) you turn on your set you see an installation introduction screen. The
Installation procedure
consists of a
series of screens that guide you through the process.
&
After an introduction screen, you are asked to select a language of the TV’s on-screen-menus. (The text of the header and the info on screen
continuously change language.)
é
Press the cursor up/down to highlight your language.
“
Press the
OK
button.
‘
Follow the on-screen instructions to proceed.
First time installation
Part 1: TV installation
(Please skip this section if you have no cable connected to the Antenna input of the TV.)
Note - The TV will take approximately 10-15 seconds to start up.
&
Select the desired
Language
and press the green button "
Next
".
é
Select
Cable
or
Antenna
in the Installation mode and press the green button "Next".
“
Auto Installation may take
20 to 40 minutes
depending on the number of channels that are transmitted by the cable provider or
broadcaster.
‘
When the TV is not receiving any signal from the antenna/cable, the message
CHANNEL NOT AVAILABLE
will appear on the TV
screen. When no transmission is received from the broadcaster, a
BLANK SCREEN
will appear on the TV screen.
Note - The TV will go on to standby after 10 minutes. Press the
POWER
button on the remote control to on the TV.
(
You will not be able to receive pay channels when using direct antenna/cable connection to the television.
§
When the Set-top box is connected to the television using coaxial cable, it is necessary to auto-program the television for the single channel
(3 or 4) that the Set-top box outputs and change the channels at the Set-top Box (using the set-top remote control) to view the program.
Refer to the manual for more details.
Note - The newly installed channels maybe sorted in a different sequence on this TV. Please key using the CH +/- buttons to get to know the
new channel. Also you can use the OK key to see the list of channels.
è
When the Set-top box is connected to the television using one of the AV connections (AV 1/ AV 2/ HDMI 1/ HDMI 2), select that input
source (using the AV button) to view the programs and change the channels at the Set-top Box (using the set-top box remote control) to
view the program.
Summary of Contents for 42MF237S - 42" Digital Plasma Hdtv
Page 7: ......
