INPUTS
Input 1:
High Sensitivity
Use this input for max pickup output and frequency re-
sponse
.
Input 2:
Low Sensitivity (6dB)
Use this input for hotter pickups.
GAIN
Controls overall gain/volume. Typically, breakup will
begin to occur around 3-4 on the dial.
TONE
Adjusts the overall high and low frequency balance of the
amplifier — fully counter-clockwise rolls off the highs,
fully clockwise rolls off the bass.
MASTER
Controls the overall volume of the amplifier.
Power tube saturation begins around 6-7 on the dial.
SELECTOR SWITCH
Off:
Bypasses the vibrato circuitry.
Mono:
Effect appears in phase at each speaker.
Stereo:
Effect applied out of phase at each speaker.
Wet/Dry:
Left speaker is affected,
Right speaker is unaffected.
Dry/Wet:
Inverts the above in the speakers.
SPEED
Controls the rate or speed of the selected effect.
The exclusive Magnatone design allows for extremely slow
“choral” settings not attainable from the original design.
When the remote pedal is connected, the front panel
control is inactive.
FM/AM SWITCH
Controls whether the effect is exclusive Magnatone pitch
shifting vibrato (FM) or conventional tremolo (AM).
AM
-
Amplitude Modulation
FM
-
Frequency Modulation
INTENSITY
Controls the amount of modulation effect.
A good balance of effect should be maintained for normal use.
STANDBY SWITCH
Allow the amplifier 1 minute to warm up before engaging.
POWER SWITCH
Turns the amplifier on and off.
Make sure you are plugged into a proper grounded outlet.
PANEL CONTROLS