Magnat Audio MONITOR SUPREME SUB 302A, Instruction Manual

Page: 9 / 44

9
AV input (2)
Connect your receiver‘s low-level subwoofer output (sub-pre-out) to the subwoofer‘s AV input (see Fig.
3). You will require a mono-cinch cable for this (not supplied).
High-level inputs (1)
For connection to the high-level (speaker) outputs of the receiver/amplifier, refer to Fig. 2.
Level control (3)
This control is used to set the bass volume according to your preferences. Proceed as follows::
1. Set the bass control of your amplifier into its centre (linear) position.
2.
Important: Set the level control to its left stop (lowest volume).
3. Now, play back some music and set the volume control of the amplifier to the desired level.
4. Set the subwoofer level control to the desired bass level.
Cross-over frequency control (4)
Used to set the upper limit of the subwoofer operating range. The cross-over frequency should be set
to 100 to 150 Hz when the system is used in combination with shelf loudspeakers or 50 to 100 Hz when
used with stand loudspeakers.
Fuse (9)
Only use a fuse with the parameters indicated inside the triangle next to the fuse holder, on the rear of
the amplifier.
MAINTENANCE
The surface is best cleaned with a mild household cleaner. On no account use furniture polish or similar
products.
SPECIFICATIONS
Monitor Supreme Sub 202A Monitor Supreme Sub 302A
Configuration: bass reflex, frontfire bass reflex, frontfire
Fitted with: 20 cm long-stroke driver 30 cm long-stroke driver
Output power RMS/Max.: 80 / 160 watts 100 / 220 watts
Frequency range: 20 – 200 Hz 16 – 200 Hz
Cross-over frequency: 50 – 150 Hz 50 – 150 Hz
Power input (Standby): <0.5 watts <0.5 watts
Dimensions (WxHxD): 265 x 365 x 345 mm 355 x 440 x 395 mm
Accessories: mains cable mains cable
Subject to technical change.