20
OxyMag_rev26
3.
Description of the Display
3.1
Modes
In the upper left corner there is the indication:
✓
Type
of
patient
selected:
ADU
→
Adult;
PED
→
Pediatric; NEO
→
Neonatal;
✓
Active Mode;
✓
NIV activation indication, this will have offset of
leaks.
3.2
Alarms, Monitor and Status
•
At the top of the screen, next to the mode indication,
there is the alarm muting button for 2 minutes, as
symbol below:
•
When activated the alarm silencing, a bar indicating
the silencing time is shown
•
At the top center, there is the display are of the
parameter always visible; this can display one of the
parameters: MV
–
Minute Volume Monitored, VEXP
–
Volume Expired or PMAX
–
Maximum Pressure.
To change the parameter displayed, touch on this
screen position.
•
At the top center, there is the STAND-BY button. By
pressing this button for at least 2 seconds, the
ventilator enters standby mode suspending
mechanical ventilation. The word ‘STAND
-
BY’ will
remain flashing while the equipment is in this
condition. By continuing pressing the button, the
sidebar will fill until complete 2 seconds. Stand-by
button is shown with the symbol below:
•
At the right top of the screen, there is the battery
charge status. As shown below:
•
At the top right of the screen, there is the area of
alarm and alert messages;
•
At the top right of the screen, a padlock will appear
indicating that the touchscreen is disabled. Press
LOCK button for at least 2 seconds, and the touch
screen is enabled.
3.3
Monitor, Menus and Charts
•
On the right side
there is a “Bargraph” for pressure,
a bar graph showing the instantaneous pressure in
the breathing circuit and the value of maximal
inspiratory pressure at the top of the bar graph in
yellow.
•
In the center of the screen there is the menu display
area, numerical ventilation parameters and graphics
3.4
Setting the ventilation parameters
•
On the bottom, there is a setting bar of the
ventilation parameters
