Installation Instructions
3
1. Remove the factory mirror (do not use excessive force). Check to make sure that the facto-
ry mirror mount matches the mounting bracket on the replacement mirror/monitor. If the
factory mirror mount does not fit the mirror/monitor’s mounting bracket, replace with the
extra mirror mount provided.
2. Slide the mounting bracket onto the mirror mount. Move the bracket back and forth until
completely seated.
3. Tighten the screw in the mounting bracket.
Control Box Connection
Connect the 8-pin extension cable to the rearview mirror/monitor 8-pin cable. Route the cable
under the headliner of the windshield then down the A-pillar behind the plastic shroud to the
under-dash area. Connect the 8-pin cable to the control box 8-pin connector.
Installing the Temperature Sensor:
1. Select a suitable location for the Temperature Sensor outside of the vehicle. The location
should be in the front of the vehicle, between the radiator and front bumper where there will
be airflow. Keep the sensor as low as possible, and as far away from the radiator as possi-
ble.
2. Use the supplied screw to secure the tem-
perature sensor to the selected location.
3. Route the temperature sensor cable
towards the firewall, securing the cable
where it doesn’t interfere with moving
parts.
4. Pass the terminals through a grommet into
the passenger compartment.
5. Route the wires up to and behind the A-Pillar, then under the headliner towards the Rearview
Mirror.
6. Connect the 2-pin connector from the sensor to the mating end of the Temperature/
Compass Y-cable.
7. Connect the 6-pin Temperature/Compass Y-cable to the rearview mirror/monitor cable.
Mounting the Mirror/Monitor:
Mounting Bracket
Rearview Mirror