MAGNABEND 650E, User Manual, Page: 4 / 36

4
ASSEMBLY ...
ASSEMBLY INSTRUCTIONS
1. Unpack the column and the feet and locate the packet of fasteners
and the 6 mm Allen key.
2. Attach the feet to the column. The pair of feet with the black and
yellow safety tape should point forwards from the column. (The
front face of the column is the side without a join in it.)
Use M10 x 16 button head screws to attach the feet.
3. Models 650E and 1000E: Attach the footplate under the tips of the
front feet. Use two M10 x 16 cap-head screws with washers.
Alignment of the screw holes will be made easier if the foot
mounting screws are left loose until after the footplate is fitted.
The M8 x 20 cap-head screws in the rear feet may be adjusted to
level the machine and suit any unevenness in the floor.
Model 1250E: A footplate is not supplied with this machine; it
must be bolted to the floor at the front feet.
4. With the aid of an assistant carefully place the Magnabend ma-
chine on the stand and secure it with M8 x 16 cap -head screws.
Models 650E & 1000E: Be sure to guide the wires and connector
down into the column as the machine is being lowered onto the
stand.
5. Models 650E & 1000E: Remove the rear electrical access panel
and plug-together the 3-pin connector. This connects the electro-
magnet in the body of the machine to the electrical unit in the col-
umn. Replace the panel.
Model 1250E: Fasten the mains-cable clip to the back of the col-
umn with an M6 x 10 pan-head screw.
6. Model 650E: Join the two halves of the tray using M6 pan -head
screws and nuts. Attach the tray (with rubber mat) to the rear of
the machine using two M8 x 12 cap-head screws. Fit two backstop
slides to the sides of the tray.
Models 1000E and 1250E: Attach the two backstop bars into the
back of the machine using two M8 x 16 screws for each bar. At-
tach the tray (with rubber mat) to the rear of the machine using
three M8 x 16 cap-head screws. Fit a stop collar onto each back-
stop bar.
7.
Attach the handle(s) with M8 x 16 cap -head screws.
Models 650E and 1000E: The handle should be slipped down
through the angle indicating ring before attaching the handle.
Model 1250E: The handle with the angle scale must be fitted on
the left side, and a stop collar slipped onto it and clamped up near
the top of the handle.