Magma
ExpressBox 3T | Chapter 2 Hardware Installation
9
Chapter 2 Hardware Installation
The following steps will guide you through the installation of your Magma Expansion
System.
CAUTION
Hardware installation shall be performed only by qualified service personnel per UL and
IEC 60950-1.
Electrostatic Discharge (ESD) Warning
All add-in cards are susceptible to electrostatic discharge. When moving cards, it is best
to carry the cards in anti-static packaging. If you need to set a circuit card down, be sure
to place it inside or on top of an anti-static surface. For more information, see “
Protecting
Against Electrostatic Discharge
” in the Preface.
WARNING
High voltages are present inside the expansion chassis when the unit’s power cord is
plugged into an electrical outlet. Disconnect the power cord from the AC outlet before
removing the enclosure cover. Turning the system power off at the power on/off switch
does not remove power to components. High voltage is still present.
CAUTION
Before touching anything inside the enclosure, move to an ESD station and follow proper
ESD procedures. Failure to do so may result in electrostatic discharge, damaging the
computer or its components. For more information, see “
Protecting Against Electrostatic
Discharge
” in the Preface.
Open Enclosure
Loosen the thumbscrew that retains the top cover of the chassis and slide the lid
towards you as shown below:
