EN
www.magmaweld.com
26
ID 500 M/MW PULSE
USER MANUAL | MANUEL D’UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
PAGE 6
It is used for saving the works performed.
Setting Range
•
Read / Write
In the “Read” status, parameters can be modified. When the “Write” status is reached, the program will be ready to be saved.
a) PROGRAM
The program number will be selected.
Setting Range
•
0-99
After selecting the “Write” option in the program line, the program number you will save will be selected from the “Program no” line. 100 programs
are available between 0-99.
b) PROGRAM NO
c) SAVE
Program saving will be performed.
Setting Range
•
yes (+) / no (-)
After selecting the program number, select “yes” on the last line “Save” button: Yes (Y) or No (N) Option H will be selected. Press + to select yes. If you
do not want to save, press “-” button to select no.
If you want to proceed with any of the previously saved programs, you can recall this previously saved program by one of the following methods;
1)
If you are at the point where you can reach the machine, the Program on the display will be as follows: You can select “Read” and recall the program
you want to use by reaching the “program no” page and perform the operations on that program.
2)
If you are not within the reach of the machine, you will need to rapidly press the torch trigger 2 times in succession so that the program reading will
be active. After pressing 2 times to switch to the desired program number, press the trigger once to switch between the programs (this period will
not exceed 5 seconds in the total of all these operations).
For Example;
If you want to switch to program 1 and if the program was on “0” before: Quickly press the torch trigger twice and the program will be ready to be
selected. After this operation, press the torch trigger one more time to select program 1. If you wish to select program 2, you will need to press the
torch trigger once again.
When the Double Pulse welding method is selected, double pulse frequency setting will be done.
Setting Range
•
0.5-5 Hz
d) D. PULSE FREQ
You can recall the programs stored in your machine’s memory with the help of the torch trigger button without having to go near the machine while
working on the workpiece.
Operation
