Magmaweld ID 250 T DC, User Manual

Page: 27 / 140

27 ID 250 - 300 T DC / TW DC
EN
www.magmaweld.com USER MANUAL
Maintenance and Service
4.3 Error Codes
Error Code Error Cause Solution
E08
E04
ERR-T1
E02
• Let the machine on for a while in
order to cool down itself with the
cooling fan. After is cools enough,
you can go on welding
• Switch off and switch on. If the
error still exists, check the mains
voltage whether it is within the
range of 340V-420V or not. If the
error still exists, contact the
authorized service
• Machine is overheated because of
high ambient temperature of
exceeding duty cycle
• Error/Errors may exist in any
electronic card
Thermal
Error
Power Module
Error
• Check the mains connection cables
and the voltage. Make sure the
correct voltage input is provided.
If the mains voltage is normal,
contact the authorized service
• Mains voltage may have decreased
Mains Voltage
Low
• Check the mains connection cables
and the voltage. Make sure the
correct voltage input is provided.
If the mains voltage is normal,
contact the authorized service
• Mains voltage may have increased
Mains Voltage
High