Magio MG-960, Instruction Manual

Page: 32 / 36

32
EN
Making espresso
(15) will light up.
10. To fill the boiler with water set the knob (6) to the « » position, in
15-20 seconds or when water starts appearing in the cup, switch off
water supply, by setting the knob (6) to the «●» position.
11. Wait till the indicator (5) lights up, then set the knob (6) to the « »
position, when the cup is filled with water, switch off water supply by
setting the knob (6) to the «●» position, pour out water from the cup.
Depending on the cup size, repeat this procedure several times, then
the boiler will be washed.
1. Make sure that the button (14) is in the «OFF» position, and the knob
(6) – is in the «●» position.
2. Remove the tank (4), fill it with cold water till the MAX mark and place
on its place.
3. Fill the filter (13) with the ground coffee using the measuring spoon (16)
till the «МАХ» mark; slightly tamp the ground coffee by the back side
of the measuring spoon (16).
4. Insert the coffee filter (13) into the holder (12), by matching the ledge
on the filter (13) with the hole on the holder (12) and turn the filter (13)
clockwise/anticlockwise.
5. Place the filter holder into the coffee maker. Holder ledges (12) should
match the groves on the boiler, and then turn the filter holder handle
(11) to the right till the clamp.
6. Place the corresponding cup on the tray grid (10).
7. Inset the plug into the socket.
8. Switch on the unit by pressing the ON/OFF (14), button, the indicator
(15) will light up.
9. Wait till the indicator (5) lights up, the unit is ready for making coffee.
10. Switch on water supply, by setting the knob (6) to the « » position,
watch the process of the cup filling with coffee.
11. To switch off water supply, set the knob (6) to the «●» position.
12. Watch the tray (9) filling, regularly pour out water and wash the tray (9).
13. Switch off the coffee maker, by pressing the ON/ OFF (14) button, the
indicator (15) will go out.
Do not remove the filter holder (12) during the operation of the
coffee maker.
To remove the filter holder (12) turn the handle to the left and remove
the holder.
After setting the operating mode knob (6) to the «●» position,
pressure will be released, the remaining hot water is supplied in
the tray (9), you will hear a sound signal and see outgoing steam on
the right side of the tray grid (10). Be careful not to get burns by the
outgoing steam.
Note