Installation
MKG Series Gas Griddle
L25-055 Rev. 0 (05/12)
7
BRACKET (2)
MOUNT FLUSH
TO FRONT
(SUPPLIED)
(SUPPLIED)
NUTS & BOLTS
INCLUDED
WITH STAND
REAR
Figure 4
1.6.3. Equipment
Stand
ATTENTION
Rear mounting brackets should be installed
to the Equipment Stand prior to placing
griddle on the stand.
IMPORTANT
Install the griddle so that the locking casters
are at the front of the unit. The casters
should be LOCKED before the unit is placed
into operation.
(See Figure 4). To mount the griddle to the
stand, locate joining kit supplied with stand. The
joining kit should include (2) rear mounting
brackets, and (4) 1/2" (13mm) mounting bolts.
To mount the griddle to the equipment perform
the steps on the following page:
IMPORTANT
The appliance must be level to perform
properly. Failure to level unit may result in
improper performance of the appliance.
NOTICE
Larger models have 6 threaded receiving
holes, but require only the four 1/2" (13mm)
bolts on each corner to mount the griddle.
1. Remove (4) existing 1/4-20 nuts and bolts
from the rear corners of the equipment
stand.
2. Align the 2 bolt holes on the rear corners of
the stand with the 2 bolt holes on the rear
mounting brackets. Orient the brackets as
shown in Figure #4 on this page.
3. Install the provided rear mounting brackets
(2) to the rear corners by using the existing
1/4-20 hardware that were removed in step
1, tighten securely.
4. Carefully place the griddle on the equipment
stand.
5. Once the griddle is on the stand, position
the griddle on the stand so that the front
edge of the base is flush with the front of
the equipment stand. If the griddle is the
only appliance to be mounted on the stand,
then both sides of the griddle should be
flush with the sides of the equipment stand.
6. When positioned properly, the threaded
receiving holes in the griddle base should
be aligned with mating clearance holes at
the front of the equipment stand, and with
the clearance holes in the rear mounting
brackets. Install the provided 1/2" (13mm) bolts and tighten securely.
Figure 5
Summary of Contents for MKG24
Page 23: ......
