Safety
Before plugging the processor in, always make sure that the power
supply matches the product specification voltage (110-220V). Do not
supply power before all components of the system are set up and
connected properly. After connecting all cables, you should mute
all outputs first or turn the gain/level settings to minimum.
!
8 Steps
1. Position your main speakers
2. Unpack your QSub
3. Install the Magico DSP Control Software from the CD
accompanying your QSub
4. Hook up your QSub
5. Position your QSub
6. Remove the casters and apply feet to the QSub
7. Determine Level of the QSub
8. Determine Crossover of the QSub
9. Determine EQ in the QSub
!
1.Position your Main speakers to achieve the flattest frequency
response possible. Adjust distance from the rear and side walls by
increments of 6” at a time to remove as many frequency response dips
as possible. Once you are satisfied with the position of the main
speakers you are ready to bring the QSub into the room and position
it.
2. Unpacking your QSub
Using a flat-head screwdriver remove the four clamps from the door.
With a 9/16” Socket bit attached to a cordless drill remove the
bolts from around the bottom of the crate. Remove the door. With
one person on each side, lift up the walls of the crate and walk it
back way from the speaker. on the top of the crate door are two
small holes, lie the door down so that the two dowels on the open
end of the crate base fit into the holes and the hinged support on
the bottom of the door is folded down to support the door/ramp.
loosen the straps holding the speaker in place and carefully lift
!
of
!
3
21
