TROUBLESHOOTING
Problem:
1) Vanity doors or drawers rub
against another surface.
2) There is an uneven gap between
the doors or drawers and cabinet.
Vanity top wobbles when placed on
the vanity base.
Possible Cause:
Floor or vanity is not level.
1) The vanity base is not installed level
and plumb.
2) The underside of the vanity top is
uneven: this can be a common
occurrence due to the manufacturing
process.
Corrective Action:
1) Use a shim to ensure the vanity is level.
2) Adjust the door hinges or drawer slides.
Figures 6 and 7.
1) Ensure the vanity base is level and plumb.
It may be necessary to use shims if the
base sits uneven (see
Step 2
in the
Installation
section).
2a) Identify which corners have the wobble.
2b) Carefully remove the vanity top and turn
it over.
2c) Apply the bumpers adhesive side down on
the corners of the vanity top that you
identified in
Step 2a
. Figure 5.
2d) Carefully place the top back onto the vanity
base and make any necessary adjustments
to the bumper placement(s) until the top
does not wobble.
Side adjustment:
Using a Phillips screwdriver, rotate screw (1)
clockwise to move the door left and
counter-clockwise to move the door right.
Moves the door up to 2 mm.
Depth adjustment:
Using a Phillips screwdriver, rotate screw (2)
clockwise to move the door forward and counter-
clockwise to move the door backwards.
Moves the door up to 2 mm.
Height adjustment:
Using a Phillips screwdriver, rotate screw
(3) clockwise to move the door upward and
counter-clockwise to move the door
downward. Moves the door up to 2 mm.
Figure 4 - Assembled
Figure 5
Figure 3
Silicone
Bumper
Bumper
Top view
Bottom view
D
Figure 6 - Adjusting Hinges
