Page 13
Switch #2
:
This is used for setting run time. If the switch is set to the OFF
position then the run time is set for 15 min for gas engines or 25 min for diesel
engines. If set to the ON position then the run time is set to 25 min for gas engines
or 45 min for diesel engines.
Jumper Wire
:
This jumper is connected when you receive the brain.
While the jumper is connected the module is set for manual transmission mode.
When installing on automatic transmissions the jumper must be cut. Please note :
if a unit with a cut jumper is installed on a manual transmission
the warranty will
be void and Firstech will have no liability.
Installation of Antennas
Once you cut the jumper wire, you are not allowed to reconnect it.
Reconnection will completely void the warranty. A trace of reconnection of this wire will prevent
you from making any claim whatsoever pertaining to the manual transmission mode.
Important!
Dip
Switch
Jumper Wire
#1
Tach Sensing
Alternator Sensing
#2
25 min run time (45 min diesel)
15 min run time (25 min diesel)
Uncut: Manual Transmission
Cut: Automatic Transmission
On
Off
Switch and Jumper Setting
Page 14
Step1:
For Programming menu 1: Press Buttons
(I+II)
for 2 seconds.
For Programming menu 2: Press Buttons
(I+IV)
for 2 seconds.
The car will chirp once indicating that you are in programming mode.
Step2:
Within a 2 seconds
after pressing
(I+II)
or
(I+IV)
, press Button
IV
the number of times to go to the option number you want to change.
You have to hear a chirp and see the parking light flash
each time when you press Button
IV
.
Step3 :
Wait a few seconds. You will hear a number of chirps and see a
number of parking light flashes corresponding to the option number
you want to change. If the number of chirps or flashes is not what
you want, go back to Step 1.
Step4 :
Press Button
I
for the default factory settings and your car will
respond by one chirp and one flash. Press Button
II
for the optional
setting and your car will respond by two chirps and two parking flashes.
Option Programming for Four Button Remotes for FM or SS Units
If you see an extended flash of the lights, you are going out of
programming mode, please go back to Step 1.
If you want to change more options, go back to Step 1.
Resetting any Option Setting to the Factory Setting
Step1:
Press Buttons (
I+II
) simultaneously or Buttons (
I+
IV
) simultaneously
for 2 seconds. A one flash of the parking lights confirms step 1.
Step2:
Press Button
III
three times. This is confirmed by a parking light flash
each time you press Button
III
. A few second later, your cars parking
lights will flash three times rapidly. Your car is now set to all of the
original factory default settings.
The antennas have been calibrated for
horizontal installation at the left-top corner
of the windshield. Different installation
may adversely affect the transmitting
distance.
