.
CHAPTER 3: SETUP & INSTALLATION
4
3. Setup and Installation
3.1 Cabling Considerations
• We recommend mounting and connecting all cabling to the HD1-DX Series
components before applying power.
• Make sure that the category cable you intend to use has been tested to comply
with the T568B wiring specification (See
Appendix A
).
3.2 Making the Connections
3.2.1 C
ONNECTIONS AND
S
ETUP IN
G
ENERAL
This section contains figures showing connections with the specific HD1-DX Series
models. In general, however, the connection and setup procedure at both
transmitter and receiver ends is as follows:
NOTE:
All HD1-DX units should be cabled and powered on prior to turning on the video
source device and display. It is recommended to cable/power on the HD1-DX units,
then the display, and lastly the video source.
At the transmitter end:
1. Connect the source video to the HD1-DX transmitter HDMI INPUT port using
an HDMI type A cable (If using DVI video an HDMI to DVI adapter is required).
2. Connect the category cable to the UTP OUTPUT port on the transmitter.
3. Apply power to the transmitter. See Figure 3-3 for LED status modes.
At the receiver end :
1. Connect the display to the HDMI OUTPUT connector of the HD1-DX receiver
(If using DVI video an HDMI to DVI adapter is required).
2. Connect the category cable to the UTP INPUT port on the receiver.
3. Apply power to the receiver. See Figure 3-3 for LED status modes.