
12
Fly Array User Manual rev 0.1
in
fo@mag-audio
.c
om
Tel./F
ax:
+
38 044 277
-4
7-89
www
.mag-audio.com
4.3. System operation - Connections and setup
Mains connection.
Fly Array systems are supplied with CN-0010 PowerCon-E/F CEE 7/7 mains
cable (part number 0204000003). Use only original or supplied by manufacturer mains cables!.
Fly Array systems are equipped with PowerCon B mains power outlets for mains link to additional
Fly system. For linking several Fly 6 full-range systems CN-0011 PowerCon link cable may be used.
(Part number 0204000004, not supplied with the system).
Fly Array systems nominal mains power specifications: AC 220V, 50/60 Hz.
Nominal voltage tolerance: 100 - 250 V.
To power the system up, connect the mains cable to the system, then to the power outlet.
To completely power down the system, disconnect the mains cable from the power outlet.
Maximum number of Fly Array systems for power linking.
Do not exceed the number of power linked system listed below:
Fly 6 - no more than 5 pcs.
Fly Sub 12 - no more than 4 pcs.
Fly Sub 15 - no more than 2 pcs.
Fly Sub 18 - no more than 2 pcs.
Signal connections.
Fly Array systems are equipped with XLR INPUT an XLR LINK connectors for
signal connection.
Use of balanced XLR connector cables is recommended. In case when balanced XLR connections are
not available, unbalanced XLR connection is acceptable.
For linking the additional system to the same signal bus LINK connector may be used.
1
2
3
Shield (Ground)
Plus (+)
Minus (-)
Balanced XLR Plug connections
Unbalanced XLR Plug connections
Fly Array systems connection
Mains power cable
CN-0010
PowerCon - Power-
Con mains link
(optional)
XLR - XLR signal link
(optional)
XLR signal
cable
1
2
3
Shield (Ground)
Plus (+)
Shield (Ground)
Fly 6
Fly 6
Fly 6
Fly 6
Fly 6
Fly 6
Fly Sub 12 Fly Sub 12 Fly Sub 12 Fly Sub 12 Fly Sub 12
Fly Sub 15 Fly Sub 15 Fly Sub 15
Fly Sub 18 Fly Sub 18 Fly Sub 18
Fly Array systems power linking
Mains
Mains
Mains
Mains