JSA200EL 5 6/3/15
JSA200EL
2-TON
CAPACITY
EXTRA LOW JACK
TROUBLESHOOTINg
Important: Service jacks are self-contained devices used for lifting, but not sustaining, a partial vehicular load. In accordance with ASME PASE Load
Sustaining Test: “A load not less than the rated capacity…shall not lower more than 1/8" (3.18mm) in the first minute, nor a total of .1875" (4.76mm)
in 10 minutes.” Lowering within this range is considered normal operation and is NOT a warrantable defect.
Problem
Action
1. Unit will not lift rated load.
Purge air from hydraulic system by following procedure under SETUP.
2. Unit will not sustain rated load or feels “spongy” under rated load.
Purge air from hydraulic system as above.
3. Unit will not lift to full height.
Purge air from hydraulic system as above.
4. Handle tends to raise up while the unit is under rated load.
Pump the handle rapidly several times to push oil past ball valves in power unit.
5. Unit still does not operate.
Contact your Mac Tools Distributor.
PROPER STORAgE
It is recommended that the jack be stored in a dry location with all wheels touching the ground on a relatively level surface.
