Maestro MR670, Owner'S Manual, Page: 4 / 25

6 7
- Never drop or insert any object into any opening on this appliance.
ATTENTION!
- Shaving foils of the shaver are very thin and sharp, easy to
damage upon non-careful use.
- Do not use the shaver with damaged blades or one of the teeth:
that can cause injury.
- Never use the device if the power cord or the plug is damaged, if
the device is not working appropriately, if the device is damaged or
fell into water. Do not repair the device on Your own, address the
nearest service center.
- Do not let the cord hang over the edge of a table or counter or
touch hot surfaces.
- Never drop or insert any object into any opening on this appliance.
- Do not press on protecting cover.
- Do not use it for commercial purpose.
Actions in extreme situations
- If your device has fallen into water or water has penetrated it,
immediately disconnect it from the mains without contacting the
device itself or the water.
- If there appears smoke, sparkling, strong smell of burning
isolation, immediately stop using or charging the device, disconnect
the device from the mains and apply to the nearest service center.
Operation
Before startup
- Remove all wrap materials and stickers
- Make sure that all the parts of appliance don’t have damages.
The shaver can be used both with battery and connected through
the charging device to the circuit.
Charging the accumulator
When using the shaver after purchasing or a long storage it must be
charged.
The temperature in the room must be from 5 to 40˚С.
Full capacity. Maximum battery capacity will only be reached after
3-4 charging/discharging cycles.
Warning!
Do not charge the battery when the temperature in the room is
below 0°C.
Do not charge the battery longer than 12 hours.
Avoid charge the battery under the direct sunlight or near the
source of heat.
- To charge the battery, switch the “Off” button (3/Picture 1) to the
position “OFF”-switched off, connect the power cord plug into the
connector on the shaver case.
- Insert the charger’s plug into power socket, the charge light
indicator will begin to light and start blinking. Full charge requires
approximately 8 hours. When the light indicator starts lighting green,
the battery is charged completely, charging is complete.
- When the charging ends, disconnect the charging device from the
power network, disconnect the cord from the shaver.
Note: during charging the cases of the shaver and the charger
become warm. This is normal.
Shaving
- Remove protecting cover.
- Turn the switcher (3/Picture 1) to the position “ON” – switched on
(towards the blades).
EN