Maestro MR650C, Owner'S Manual

Page: 4 / 25

6 7
- Do not place or store appliance where it can fall or be pulled into a
bath or sink.
- Do not use while bathing or in a shower.
- Do not place the appliance on any surface while it is operating.
- Never drop or insert any object into any opening on this appliance
WARNING! Do not use this appliance with a damaged or broken
comb nor with teeth missing from the blades as injury may occur.
- Before use, make sure certain blades are oiled and aligned
properly.
- Do not cut wet hair, before cutting dry and comb hair.
- Do not cut hair when there are dermatitis.
- Do not use this appliance for grooming pets.
THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY. DO NOT
USE THE APPLIANCE FOR ANYTHING OTHER THAN INTENDED
USE.
- Do not use it for commercial purpose.
Actions in extreme situations
- If your device has fallen into water or water has penetrated it,
immediately disconnect it from the mains without contacting the
device itself or the water.
- If there appears smoke, sparkling, strong smell of burning
isolation, immediately stop using the device, disconnect the device
from the mains and apply to the nearest service center.
Operation
Before startup
- Remove all wrap materials and stickers
- Make sure that all the parts of appliance don’t have
damages.
Oil
- To maintain your clipper in peak condition, the blades should be
oiled every few haircuts.
- Do not use hair oil, grease oil mixed with kerosene or any solvent,
as the solvent will evaporate and leave the thick oil which may slow
down the blades motion.
- Add a few drops of oil to the blades, turn clipper on for a few
moments, turn off and unplug. Wipe off any excess oil.
Blade lever
-The lever is conveniently located near your thumb (if you’re right-
handed) so it can readily be adjusted while the clipper is in your
hand.
-The lever adds versatility to your clipper by allowing you to
gradually change the closeness of your cut without an attachment
comb.
-When the lever is in the uppermost position, the blades will give
you the closest cut and -leave the hair very short. Pushing the lever
downward gradually increases the cutting length. See Picture 2
(page 2).
-In its lowest position, the lever will leave the hair approximately the
same length as the #1 comb.
-The lever will also extend the use of your blades since a different
cutting edge is used in each setting. In addition, if extremely heavy
hair cutting has jammed the blades, it will help you remove hair that
has become wedged between the two blades without removing the
blades.
-While the clipper is running, rapidly move the lever from “close
EN