Chapter 2
Installation
2.1
Inserting SIM card and battery
Use a small Philips head screwdriver to remove the two screws of the battery cover. The gently slide the cover
out.
Under the cover you will see the battery and the hardware configuration DIP switches.
Take the battery out of its slot to reveal the SIM card holder. Slide and rotate the holder, insert the SIM card
and put the holder back in closed position. Make sure that the SIM card holder is correctly secured.
If you need to modify the hardware configuration through the DIP switches, now is the good time. Consult
Maestro or your distributor if you are not sure about the correct position of the switches.
Now put back the battery into its slot, and connect the battery connector to the socket on the M2MBoxPro
motherboard. The socket is foolproof so you can not connect the battery wrongly.
When shipping from Maestro, the battery will always be disconnected. Do not forget to connect the battery
before using the M2MBoxPro.
2.2
Mounting the M2MBoxPro
The M2MBoxPro is designed to be mounted on 35mm DIN rail.
First align the bottom part of the mount groove of the M2MBoxPro against the bottom side of the DIN rail, then
push the device against the rail until you hear a click sound. The M2MBoxPro is now secured on the DIN rail.
To remove the M2MBoxPro from the DIN rail, use a flat head screwdriver to lift the top blue DIN clip of the
device, then take out the device. In case the blue DIN clip falls off the M2MBoxPro, put it back in its slot.
2.3
Connect the external antenna (SMA type)
Connect this to an external antenna with SMA male connector. If you are using a different antenna than the
one provided, make sure it is for the GSM frequency with impedance of 50ohm, and also connector is secured
tightly.
Confidential, the whole document is the sole property of Maestro Wireless Solutions ltd.
3603-9, 36/F., 118 Connaught Road West, Sheung Wan, Hong Kong
13
