Maeda D3001, Operation Manual

Page: 85 / 294

M A E D A Mini-Crawler Crane Section 4 – TRAVELLING POSITION
3/2019 MC305C-3 4-21
TRAVELLING POSITION
WARNING!
• When moving this machine self-propelled,
take the "travelling posture" with which the
boom, hook block, and outriggers are
stowed.
• Travelling or travelling hoist with the boom
extended is essentially prohibited. This will
overturn the machine, causing serious
injury accidents.
• Do not use this machine for other purpose
than the major purpose such as using it for
carrying the load on the machine.
• Follow the local laws and regulations if
driving the machine on public roads.
Take the travelling posture shown on the below
when moving the machine.
Fig. 4-51
1. See "Crane Stowing Operation" on page
4-57 to stow the crane. Stow the hook block
in the specified position.
2. See "OUTRIGGER STOWING" on page
4-45 to stow the outriggers.
TRAVELLING CONTROLS
AND OPERATION
WARNING! Not observing these cautions in
travelling will result in serious accidents.
Cautions When Travelling
• When travelling, stow hook and outrigger,
and make sure the surrounding safety.
• When stowing outriggers, insert each
position pins completely to lock.
• Be seated to operate travelling.
• Travelling over the boulder stones or a
stump not only causes the overturning of
the machine, but also gives an impact to
the machine (especially around crawlers),
causing breakage.
• Avoid or remove the obstacles not to travel
over it whenever possible.
• If you have to travel over the obstacles by
necessity, be sure to take the "travelling
posture" to lower the centre of gravity, and
reduce the travelling speed as much as
possible so that the machine will go over
the obstacles at the centre of the crawlers.
NOTICE: See "TRAVELLING POSITION" on
page 4-21 for the travelling posture of the
machine.
Fig. 4-52