Maeda D3001, Operation Manual

Page: 74 / 294

Section 4 – INSTRUMENT PANEL SECTIONS Mini-Crawler Crane M A E D A
4-10 3/2019 MC305C-3
NOTES: When restarting the engine after
overriding, be sure to turn the engine emergency
stop switch (EMO) to the "OFF" position before
starting the engine.
Starter Switch
CAUTION: Always turn the starter switch to
the "OFF" position after completing the
work.
NOTICE: When inserting the key for the starter
switch, slide the cover to the left so that you can
see the keyhole of the switch, and then insert the
key.
Fig. 4-18
Use this switch to start and stop the engine.
Fig. 4-19
• HEAT: Turn the key to this position when
starting the engine in the cold
weather.
• OFF: You can insert/remove the key at this
position. All the switches in the
electrical system are turned off and
the engine stops.
• ON: Electricity runs into all the circuits.
• START: When the engine has started, release
your hand from the key. The key
automatically returns to the "ON"
position.
Emergency Stop Cancel Switch
WARNING!
• Do NOT set the emergency stop cancel
switch to ON position during crane work.
Such attempt prevents automatic stop
from occurring even under overwound
condition during crane work, thus may not
only cause the hoisted load to collide and
damage crane parts but may cause the
load to drop and cause a serious accident
or cause the machine to trip.
Keep the switch key extracted during
normal crane works.
Monitors
CAUTION: If the monitor flashes during the
work, stop the operation immediately and
check, adjust, or repair the relevant section.
Fuel Gauge
This gauge indicates the remaining amount of
the fuel in the fuel tank.
Turn the starter switch to the "ON" position and
the gauge indicates the remaining amount of the
fuel with the "bar".
When only one "bar" lights up on the "E" side,
there is not much fuel left.
Stop the operation immediately and refuel.
Fig. 4-20
NOTICE:
• At the end of a day, fuel to full (until all the bars
(10 bars) light up.)
• The remaining amount indicated may not be
correct for a while after the starter switch is
turned to the "ON" position. This is normal.