MADRIX ORION, Technical Manual & Quick Start Manual, Page: 14 / 36

13
EN
3) Device Configuration
You can access and change specific device settings, including the IP address, pin
input, DMX channels, input sent to network, and more.
Please note: In order to put MADRIX ® ORION fully into operation, configure the
device according to your requirements and input equipment.
Web Configuration Through A Web Browser
Step 1) Connect MADRIX
® ORION and your computer to the same network.
Step 2) Assign correct network settings in the computer's operating system.
(Recommended: IP address 10.0.0.1 / Subnet mask 255.0.0.0)
Step 3) Open your web browser and enter the IP address of MADRIX ® ORION.
(You can find the default IP address on the side of the ORION device.)
Step 4) The built-in web configuration tool will be launched. Confirm or
change the settings as required. The device then sends out data (over
network) as configured.
Step 5) Change any other settings as required. Apply changes with 'Set'.
For more information, see the MADRIX ® ORION User Manual.
Basic Configuration Using The MADRIX ® HARDWARE MANAGER Software
Step 1) Connect devices to your computer over USB or network, but not both!
Step 2) Make sure to stop sending control data to the devices!
Step 3) Start the MADRIX
® HARDWARE MANAGER Software.
Step 4) In MADRIX ® HARDWARE MANAGER, go to the tab 'Devices' and
confirm or change the network settings and any other settings for your
devices as required.
On a selected device, use Right Mouse Click > 'Open Device
Configuration Via HTTP...' to open the web configuration through a
web browser, as explained above.
On a selected device, use Right Mouse Click > 'Restore Factory
Default Settings' to perform a reset to factory default settings.
For more information, see the MADRIX ® HARDWARE MANAGER User Manual.
The software is available for download from www.madrix.com