MADRAX MADLOCKER ™ Assembly Instructions
MADRAX DIVISION
MLV-1
GRABER MANUFACTURING, INC.
10-3-18
Page 2 of 6
STEP 2
Attach the
HINGE
with
1/4-20 x 1/2" Button Head Socket Cap Screws.
It is important that the
HINGE
is parallel and straight to the front face of the door.
The easiest method is to push the
HINGE
down toward the front of the door while
tightening the screws.
Verify that all hardware is tight, especially the handle hardware.
STEP 3
If this is a bank of lockers please see Locker Connection Instructions
before installing the feet.
Install the
1/2”
-13 x 3 1/2" Carriage Bolt
and
1/2”
-13 Nut,
which are
used as
LEVELING FEET
, into the
DOOR JAM ASSEMBLY,
finger
tighten with the head of the bolt appro
ximately 1” below
the
DOOR JAM ASSEMBLY
.
STEP 4
The top of the
SIDE
has 3 holes. Be sure it is right side up. Attach the
DOOR JAM ASSEMBLY
to the
SIDE
with
1/4”
-20 x 1/2" Button Head Socket Cap Screws.
Only attach the
SIDE
to the
DOOR JAM
ASSEMBLY
by the top and bottom screw at this time. The remaining holes will be used to attach
the
HINGE
.
1”
