Madison Electric Products, Inc
.
2605 N. Berkeley Lake Rd. NW, Ste. 300 • Duluth, GA 30096 • P: 1-800-631-7775 • F: 1-216-391-7912
© 2019/02313
FIGURE 1
With Support Frame (A) on flat surface, push down firmly
on Frame Connector (C) until ball pin in Support Frame
(A) snaps into hole in Frame Connector (C). Repeat for
the second Frame Connector.
FIGURE 2
Slide one Small Washer (P) onto the Wheel Axle (G),
followed by one Wheel (H), and one Large Washer (M).
Insert the wheel/axle assembly into the bottom hole of
the Support Frame (A) and secure using one Cotter Pin
(O), bending both sides of Cotter Pin upward to lock into
place. Install the second Small Washer (P) onto the other
end of the Wheel Axle (G), followed by the remaining
Wheel (H), and Large Washer (M).
FIGURE 3
Line up Support Frame (B) over the Frame Connectors
(C) and Wheel Axle (G). Insert the wheel/axle assembly
into the bottom hole of the Support Frame (B). Push
down until ball pins in Support Frame (B) snap into the
holes in the Frame Connectors (C). Insert the other Cotter
Pin (O) into the end of the Wheel Axle (G), bending both
sides of Cotter Pin upward to lock into place.
FIGURE 4
With Wire Guide facing down, position the Top Frame
Connector (D) in between the Support Frames (A and B).
Secure using the 1/4-20 x 1-1/2" Carriage Bolt (J), 1/4" x
1/2" Flat Washer (K), and 1/4-20 Nylon-Insert Locknut (L).
FIGURE 5
With the unit in a horizontal position, insert the Bottom
Frame Connector (E) into the holes in the Support
Frames (A and B). Push down equally on both sides until
ball pins in the Bottom Frame Connector (E) snap into the
holes in the Support Frames (A and B).
FIGURE 6
Insert the Zinc Plated Reel Shafts (F) through the holes in
the front of Support Frames (A and B), secure using 3 x
65 Hitch Pin Clips (N).
ASSEMBLY INSTRUCTIONS
FIGURE 4
Top Frame
Connector (D)
Flat Washer (K)
Nylon
Locknut (L)
Carriage
Bolt (J)
Carriage
Bolt (J)
FIGURE 6
Reel Shaft (G)
Hitch Pin
Clip (N)
FIGURE 3
Support
Frame (A)
Support
Frame (B)
Wheel
Assembly
Push Down
FIGURE 5
Support
Frame (A)
Support
Frame (B)
Bottom Frame
Connector (E)
Top Frame
Connector (E)
Frame
Connector (C)
Push
Down
Push
Down
Frame Connector (C)
Support Frame (A)
FIGURE 1
Support
Frame (A)
FIGURE 2
Large
Washer (M)
Large
Washer (M)
Small
Washer (P)
Wheel Axle (G)
Wheel (H)
Cotter Pin (O)
