Madimack INVPLUS1100, Installation & User Manual

Page: 10 / 12

7
5.5 Parameter setting
Under OFF mode, hold for 3 seconds to enter parameter settings.
Parameter Description Default setting Setting range
1 Priming time 1 minutes 0~10min, by 1 minute increments
2 Minimum RPM 1200rpm 1200~2000rpm, by 100rpm increments
3 Di2 2900 rpm 1200~2900rpm, by 100rpm increments
4 Di3 2400 rpm 1200~2900rpm, by 100rpm increments
5 Di4 1200 rpm 1200~2900rpm, by 100rpm increments
6 Priming RPM 2900 rpm 1200~2900rpm, by 100rpm increments
6. PROTECTION & ERROR CODES
Item Code Description Analysis
1 E001 Abnormal input voltage Not faulty
2 E002 Output over current Not faulty
3 E101 Heat sink over heat Contact your supplier
4 E102 Heat sink sensor error Contact your supplier
5 E103 Master driver board error Contact your supplier
6 E201 Circuit board error Contact your supplier
7 E202 Master board EEPROM reading failure Contact your supplier
8 E203 RTC time reading error Contact your supplier
9 E204 Keyboard EEPROM reading failure Contact your supplier
10 E205 Communication error Contact your supplier
11 AL01 Auto speed reduction against high temperature Contact your supplier
Note
:
1. AL01 is not an error indication: when it appears the inverter will automatically switch to a
lower speed to self protect against high internal temperature. When the temperature drops
back to normal operating range (65
℃ ) the inverter will resume at the preset speed. If this
happens often please check correct ventilation requirements and move out of direct sunlight.
2. If code E002/E101/E103 occurs, and the cause for the code appearing is cleared. I.e E101
heat sink is within normal operating range again the device will resume working automatically,
however when it appears a fourth time, the device will stop working and display the code
continuously, to resume operation, disconnect power to the device by unplugging and power
restart again.
If code continues to be displayed please contact the Madimack support line on
1300 899 737 or email support@madimack.com.au