5
1. Main Components
2. Connection and Operation
Place the control box in a shaded and dry place at least 3m away from
the pool edge, to avoid direct sunlight.
Lay out the cleaner’s buoyancy cable straight without any twists, and then
insert one end of the buoyancy cable into right interface of the control box, and
tighten the nuts.
2.1 Preparation Before Cleaning
The control box should be placed on a table or other platform off the ground.
Do not use this product in the swimming pool immediately after or during the adding of chemicals and
salt. Do not operate with liquid flocculating agent or other clarifying agents, otherwise, it may block or
damage filter components of the cleaner.
The cleaner and the control box may power off automatically due to triggering of high-temperature
if used in working temperature beyond stipulation or subject to high-strength and extended direct
sunlight, which may cause damage to the product in severe conditions.
When the cleaner is working, please do not
touch the rotating components with hands
directly.
Please use the cleaner in the following
specified environment:
Hold the handle when placing the cleaner into water or taking it out of water, do not lift the cleaner out
of the pool pulling the buoyancy cable directly.
Working Depth
0.8-5m
pH
7-7.8
Chlorine
Maximum 5ppm
Working Temperature
10-35 °C
Salt
Maximum 5000 ppm
1.
2.
Madimack Installation Manual GT560.indd 5
Madimack Installation Manual GT560.indd 5
19/5/2023 5:06 pm
19/5/2023 5:06 pm
