Temp100, Temp101, Temp110 and TempRetriever
Product Quick Reference Card
Product Notes
Manual Start
When the
Manual Start
method is selected, the data logger
will be armed, but not recording. To start the device, hold the
push button down until both the green and red LEDs flash
momentarily.
LEDs
Once started, the LED will flash at the selected reading rate to
indicate that the device is running. The LED will flash in one
second intervals if there is an alarm condition.
If the device has two LEDs, the green LED will blink at the
specified reading rate. The red LED will blink if the alarm has
been breeched.
Alarm Settings
To change the settings for the temperature alarm;
- Select
Alarm Settings
from the
Device menu
in the MadgeTech
software. A window will appear allowing the customer to set the
high and low temperature alarms.
- Press
Change
to edit the values.
- Check
Enable Alarm Settings
to enable the feature. The values
can be entered in the field manually or by using the scroll bars.
- Click
Save
to save the changes. To clean an active alarm, press
Clear Alarm
.
Installation Guide
Installing the Interface cable
- IFC200, IFC202 or IFC300
Refer to the “Quick Start Guide” included in the package.
- IFC110, IFC102 or IFC103
Plug the serial cable into the port and verify it is secure.
- USB-1 or USB-101
Install the USB drivers from the CD provided in the kit, than
plug the USB cable into the computer and the serial cable into
the serial port.
Installing the software
Insert the Software CD in the CD-ROM Drive. If the autorun
does not appear, locate the drive on the computer and double
click on
Autorun.exe
. Follow the instructions provided in the
Wizard.
Connecting the data logger
- Once the software is installed and running, plug the interface
cable into the data logger.
- Click the
Communication Menu
, then
Auto Configure Port
.
- After a moment, a box similar to the following will appear;
- Click
OK
. The
Device Status
box will appear. Click
OK
.
- At this point, communications have been configured for your
logger. These settings can be found under the
Communication
Menu
.
Note: For additional installation instructions refer to your “
Data
Logger & Software Operating Manual”.
Device Operation
Starting the data logger
- Click
Device Menu
then
Start Device
.
- Choose the desired start
method.
- Choose the start parameters
by selecting a
Reading Rate
suitable for your application.
- Enter in any other desired
parameters and click
Start
.
- A box will appear stating the
data logger has been started.
Click
OK
.
- Disconnect the data logger from the interface cable and
place it in the environment to measure.
Note: The device will stop recording data when the end of
memory is reached or the device is stopped. At this point the
device cannot be restarted until it has been re-armed by the
computer.
Downloading data from a data logger
- Connect the data logger to the interface cable.
- Click the
Device Menu
then
Read Device Data
. This will
offload all recorded data onto the PC.
Technical Support
Visit www.madgetech.com, or call (603) 456-2011.
Technical support is also available by e-mailing
[email protected]
Additional product information is available by e-mailing
[email protected].