MadgeTech LF101A, Product User Manual

Page: 4 / 4

PRODUCT USER GUIDE
LF101A
DOC 1240035-00 | REV 6 2020.06.01
NEED HELP?
6 Warner Road, Warner, NH 03278
(603) 456-2011
info@madgetech.com
madgetech.com
Product Support & Troubleshooting:
• Visit our Resources online at
madgetech.com/resources
.
• Contact our friendly Customer Support Team at (603) 456-2011 or
support@madgetech.com
.
MadgeTech 4 Software Support:
• Refer to the built-in help section of the MadgeTech 4 Software.
• Download the MadgeTech 4 Software Manual at
madgetech.com
.
• Contact our friendly Customer Support Team at (603) 456-2011 or
support@madgetech.com
.
Device Operation (cont’d)
Multiple Start/Stop Mode Activation
• To start device:
Press and hold the pushbutton for 5
seconds, the green LED will flash during this time. The
device has started logging.
• To stop the device:
Press and hold the pushbutton for
5 seconds, the red LED will flash during this time. The
device has stopped logging.
Trigger Settings
The device can be programmed to only record based off
user configured trigger settings.
1. In the
Connected Devices
panel, click the device
desired.
2. On the
Device
Tab, in the Information Group, click
Properties
. Users can also right-click the device and
select
Properties
in the context menu.
3. Select Trigger Settings from the Device Menu: Start
Device or Identify Device and Read Status.
Note:
Trigger formats are available in Window and Two Point (bi-level)
mode. Window allows for one range of monitoring and two point mode
allows for two ranges of monitoring.
Device Maintenance
Battery Replacement
Materials: Small Phillips Head Screwdriver,
3/32" HEX Driver and a Replacement Battery (LTC-7PN)
1. Remove the Data Logger from the Waterbox101A using
the Allen Key.
2. Puncture the center of the back label with the screw
driver and unscrew the enclosure.
3. Remove the battery by pulling it perpendicular to the
circuit board.
4. Insert the new battery into the terminals and verify it
is secure.
5. Screw the enclosure back together securely.
Note: Be sure not to over tighten the screws or strip the threads.
Recalibration
Recalibration is recommended annually. To send devices
back for calibration, visit
madgetech.com
.