B
Once the IFC200/202 is plugged in, a
New
Hardware Found
message will appear on the PC.
The new drivers will automatically configure for use
with the Interface cable. A message will then appear
that the new hardware is installed and ready to use.
The installation of the USB data logger interface is complete.
Plug the stereo cable into the open jack on the IFC200/202, the opposite end of the cable
will be plugged into the data logger.
To verify that the USB Interface drivers are installed properly, check to ensure the Data
Logger Software can recognize a device.
When the interface cable is connected to the PC the blue LED power indicator light should
be on. If the indicator light is
not
on, unplug the interface cable, wait 5 seconds and plug it
back into the PC.
Start the MadgeTech Data Logger Software. (If necessary, see the Software Manual for
additional information on the software)
Your device(s) will appear in the list displayed, select your device in this list and choose your
desired start method.
3
Test the Data Logger Interface Operation
A
B
C
D
