MADER LSE2203, Operator'S Manual

Page: 62 / 80

DANGER
Log splitter engine exhaust contains carbon monoxide, a colourless, odourless, poison gas.
Breathing carbon monoxide will cause nausea, dizziness, fainting or death. If you start to feel dizzy or
weak, get to fresh air immediately.
Operate log splitter outdoors only in a well-ventilated area.
DO NOT operate the log splitter inside any building, enclosure or compartment.
DO NOT allow exhaust fumes to enter a confined area through windows, doors, vents or other
openings.
DANGER CARBON MONOXIDE , using a log splitter indoors CAN KILL YOU IN MINUTES.
CAUTION
Fuel and fuel vapours are highly flammable and extremely explosive.
Fire or explosion can cause severe burns or death.
Unintentional start-up can result in entanglement, traumatic amputation or laceration.
Only use regular unleaded gasoline with a minimum 86 octane rating.
DO NOT mix oil and gasoline together.
Fill tank approximately ¼” below the top of the tank to allow for fuel expansion.
DO NOT fill fuel tank indoors or when the engine is running or hot.
DO NOT light cigarettes or smoke when filling the fuel tank.
STEP 9: Add Hydraulic Oil
1. The log splitter needs to be on a flat, level surface before adding the hydraulic oil.
2. Remove the oil cap from the hydraulic reservoir.
3. Add 3 gallons of hydraulic oil AW32, AW46 & universal hydraulic oil are all acceptable types of
fluid. Automatic transmission fluid should be used when operating in temperatures
below 32 degrees (all units are tested and have excess oil in the ram).
4. Check the hydraulic oil level.
5. Start engine and use the control lever to extend and retract wedge several times to remove air
from the lines.
6. With the wedge retracted, check hydraulic oil level again and fill if necessary.
WARNING
DO NOT remove the hydraulic oil fill cap when the engine is running or hot. Hot oil can escape
causing severe burns. Always allow the log splitter to cool completely before removing the hydraulic
oil cap.
High fluid pressure and temperatures are created in the hydraulic log splitters. Hydraulic fluid will
escape through a pin-size hole opening and can puncture skin and cause severe blood poisoning.
Inspect hydraulic system regularly for possible leaks. Never check for leaks with your hand while
the system is pressurized. Seek medical attention immediately if injured by escaping fluid.
Make sure all fittings are tight and secure before applying pressure. Relieve system pressure before
servicing.
Make sure the hydraulic hoses do not touch any hot surfaces or cutting areas.
Hoses need to be positioned where they are clear from the engine and cutting wedge. To avoid
serious bodily injury always inspect the hoses before operating the log splitter.
Operation Instructions